Low Flow Rate Fine Fog Nozzles/ Flat Spray BIMV series nozzles   Thread standard - Pipe conn. size - Standard pressure - Spray angle 45°, 80°, or 110° (*1) Spray capacity 1.0–107 ℓ/hr Supply air type Compressed air Liquid feeding system Liquid pressure Mean droplet diameter 20–100 μm Air consumption 7–245 ℓ/min, Normal Air pressure 0.2–0.4 MPa Free passage diameter 0.2–1.6 mm (*2) Features • Flat spray pneumatic nozzle producing fine atomization with a mean droplet diameter of 100 μm or less (*3). • Features large turn-down ratio under liquid pressures of 0.1–0.3 MPa. • Produces two different spray distributions: uniform spray distribution throughout spray pattern area (when spraying at a low air-water ratio), or a mountain-shaped distribution having gradually tapered edges (at a high air-water ratio). • Spray angle of 110ﾟ, 80ﾟ, or 45ﾟ. *1) Spray angle measured at compressed air pressure of 0.3 MPa and liquid pressure of 0.1 MPa. *2) Free passage diameter of nozzle orifice. *3) Measured by Laser Doppler Method. Applications Spraying: Mold release agent, lubricant, deodorant (trash pit, refuse collector, inlet conduit), oil, surface treatment agent, rust preventive, honey, insecticide, aqueous urea, etc. Cooling: Dies, gas, glass, steel plates, steel pieces, moldings, automobile bodies, plastic products, etc. Moisture control: Paper, gas, ceramics, concrete, etc. Cleaning: Printed circuit boards, glass tubes, etc. Others: Dust suppression, catalyst denitration, etc. [Steelmaking industry] Raw material process: Dust suppression at the conveyor line, Flue gas denitration reducing agent Steelmaking process: Cooling refractories at maintenance of ladle and tundish, Cooling electric furnace and electrode Rolling mill process: Cooling coil Surface finish process: Minimized spangle treatment at the continuous galvazing line, Cooling coating line Industries in which this nozzle is used • Electronics • Paper & pulp • Printing • Food