日本Miyoshi三好万向接头HSD-16-TT Anti-corrosive Type HSD, BSD boots axis addition 60° 30° Stainless Steel SUS304 Dry lubrication treatment is carried out to improve the anti-wear characteristics. ( over HSD-16) A hole for a spring-pin and a taper-pin attached should be machined together with a shaft at a location of ℓ/2. Designate new JIS or old JIS for key, when the type of shaft-hole shape is B or T. A spring-pin is not attached for a joint with a key way. (1) in water or in water and air alternately (2) in acidic liquid (3) in alkaline liquid (4) for anti-corrosive and heat-resistant use ■Type HSD・BSD Dimension Table Attachment： spring-pin 2 pieces(SUS420J2)   φdH7 φD L ℓ Ⅰ F New JIS key Old JIS key TAP M Dimension of spring-pin for fixing Swing of the center Mass kg Max. revolution min-1 Max. transmission torque capacity N・m aJs9 b aJs9 b HSD-6 6 12.5 65 13 20 25 2 1.0 2 1.0 M3 2×12 0.10 0.04 640 2 HSD-8 8 16 80 16.5 25 30 3 1.4 3 1.5 M3 2.5×16 0.10 0.08 570 7 HSD-10 10 20 90 17 28 34 3 1.4 4 1.5 M4 3×20 0.14 0.15 460 12 HSD-12 12 25 112 22 35.5 41 4 1.8 4 1.5 M4 4×25 0.14 0.31 380 20 HSD-14 14 25 112 22 35.5 41 5 2.3 5 2.0 M5 4×25 0.14 0.29 380 20 HSD-16 16 32 134 23 40 54 5 2.3 5 2.0 M5 5×32 0.14 0.58 280 49 HSD-20 20 40 164 28 50 64 6 2.8 5 2.0 M6 6×40 0.20 1.11 230 93 HSD-25 25 50 206 36 63 80 8 3.3 7 3.0 M8 8×50 0.20 2.20 180 180 BSD-30 30 60 275 56 89 97 8 3.3 7 3.0 M8 10×60 0.25 4.12 150 282 ※You may download 3D CAD drawings by clicking on the part number of interest.