Mass Flow Sensor Model MCS100 www.azbil.com Can measure mass flow rate according to the standard condition (20℃, 1 atm) of gas without temperature nor pressure compensation. Small and light weight which can be installed wherever, it’s suited for a variety of flow measurements in such as laboratory and various industry applications. (33.5 x 10.5 x 17.0 mm, just 9g, without cable) Fast response time : 5ms Bidirectional flow range Low power consumption: 12mA max. at 24Vdc Free mounting position and not required straight piping length Measurement flow range line-up MCS100A104 : 0 to 3L/min MCS100A112 : 0 to+500mL/min MCS100A116 : 0 to 5L/min MCS100A120 : 0 to 10L/min MCS100A100 : -3 to +3 L/min MCS100A108 : -500 to +500mL/min MCS100A128 : -10 to +10L/min Construction specification Typical applications - Measures the mass flow rate intake of the pump without effects from temperature fluctuation or changes in atmospheric pressure. - Operates on battery power on handheld equipment. - Useful for control of oxygen flow rate from compressor, without effects from fluctuation in room temperature or altitude. - Useful for replacing from a float meter. - Measures flow rate of air supplied to eliminate heat haze. - Measures flow rate of nitrogen supplied to prevent oxidation. - Useful for replacing from a float meter or pressure gauge. - Can be installed close to the pick-up nozzle. - Fast response is suitable for pick-up detection. - Measures slight differences in flow rate which cannot be detected by pressure. - Not affected by fluctuation in suction pressure, thanks to mass flow measurement. - Clogged or crushed nozzle is detectable by analog output. pick-up