Power-I/O cable with HRS 6-pin connector and open end. Info The cable is suitable for the following camera models: ace GigE (cable not recommended for use with GPIO) aviator CL (power only) Order Number Cable Length 2200000189 5 m 2000029411 10 m Cable Drawing# CAUTION – Personal Injury Hazard       Wiring Information# Pin Number Wire Color ace GigE without GPIO ace GigE with GPIO aviator CL 1 Brown Camera Power Camera Power Camera Power 2 Pink Opto-isolated IN (Line1) Opto-isolated IN (Line1) Camera Power 3 Green Not connected GPIO (Line 3) Not connected 4 Yellow Opto-isolated OUT (Out1) Opto-isolated OUT Not connected 5 Gray Opto-isolated I/O Ground Opto-isolated I/O Ground Camera Power Ground 6 White Camera Power Ground Camera Power and GPIO Ground Camera Power Ground For more details, see the respective camera documentation. Physical Specifications# Camera-side Connector Hirose 6 pin [HR10A-7P-6S (73)] Host-side Connector None, open end Cable Cross-section 3 x 2 x 0.14 mm² (close to AWG 26) Cable Diameter 5.8 mm Wire Insulation PVC Outer Jacket PVC Minimum Bending Radius 34.8 mm (6 x cable diameter), fixed installation Maximum Bending Cycles None (fixed installation only) Suitable for Drag Chain Applications No Suitable for Robotics Applications No Electrical Specifications# Maximum Operating Voltage See camera documentation for the power requirements of your camera. Test Voltage 1200 VDC Wire Resistance ≤142 Ω/km Environmental Specifications# Operating Temperature Range -25–80 °C, not moving Plug Specifications# Durability >1000 mating cycles Contact Resistance 10 mΩ max. Contact Plating Gold Protection Rating IP40 Plug Insulation Material Polyamide/PBT